NITEK Active Video Balun Set EX560

Model

EX560	Active Video Balun Set For Transmission of CCTV over Unshielded Twisted Pair (UTP) transmission from 500 feet (150 meters) to 6,000 feet (1,800 meters).

Description:

The EX560 is a complete Twisted Pair Video system made up of a TR560 receiver unit and a TT560 transmitter unit. The system is designed to operate over Category 2 or better twisted pair cable. It works well over existing communication, computer network spare pairs, or new cable installations. A highly balanced transmitter output assures that the system will not interfere with other network equipment. Advanced receiver and transmitter electronics provide optimum video quality and complete immunity from ground loop, hum and noise. Both the transmitter and receiver provide adjustment for gain and frequency compensation allowing the system to be “finetuned” for the cable. These unique adjustments provide optimum performance over the entire operating range of the system and allow cable lengths to be estimated with a wide safety margin. The receiver and transmitter units each require 24 VAC power. In multiple receiver and/or transmitter applications a common supply can be used for the system.

Features:

Active electronics compensate for frequency and level loss providing the highest quality video
High resolution color or monochrome video
Immunity to ground loop. Video and AC can be run in a common raceway, where code allows
Built-in protection from power surges, transients, static or other electrical interference
Video can be run in the same cable with telephone and computer signals
Weather resistant design
Easy to install

Receiver Unit
Size	1.6” (H) x 4.30” (W) x 2.4” (D)
Power Requirements	24VAC@1watt (1VA)
Input	Balanced low voltage current loop
Output	1 vpp composite video Monochrome or Color
Common Mode Rejection	>70dB
Shipping Weight	2 lbs
Transmitter Unit
Size	1.6” (H) x 4.30” (W) x 2.4” (D)
Power Requirements	24VAC@1watt (1VA)
Input	1 vpp composite video Monochrome or Color
Output	Balanced low voltage current loop
Common Mode Rejection	>70dB
Humidity Range	0 to 98%, non-condensing
System
Video Format	RS170, NTSC, PAL, SECAM, CCIR (Color or B/W)
Video Input	1 vpp composite video monochrome or color
Operating Frequency	1 Hz to 10 MHz
UTP Category	Unshielded Category 2 or better
Temperature Range	-40 degrees C to +85 degrees C

EX560 Active Video Balun Set For Transmission of CCTV over Unshielded Twisted Pair (UTP) from 500 ft to 6,000 ft

Product Specifications

EX560 Spec Sheet	--	TR560 dwg
EX560 A&E Spec	EX560 A&E Spec	TT560 dwg
EX560 Manual	--	--

Applications:

Large Campus Installations
Shopping Malls
Airports
High Voltage Facilities
Traffic Around City Areas
Remote Gates

Wire and Cable Recommendations

Twisted Sender systems are recommended for use with unshielded twisted pair (UTP) wiring. The systems will operate over wire gauges from 26 AWG through 12 AWG but are optimized for 24 AWG. Category 2, 3, 4, 5, 6 or 7 cable may be used. Individually shielded pairs should be avoided, as they drastically reduce the operating range of the systems. Multi-pair cable (>15 pairs) with an overall shield is acceptable. Video can be operated in the same communication cable co-existent with telephone, computer, control signals, power voltages and other video signals. While video may be routed through telephone punch down block terminals, any bridge-taps, also called Ttaps and any resistive, capacitive or inductive devices MUST BE removed from the pair.
specific information regarding wire types, gauges and proper installation techniques, please call (800) 528-4343 for technical assistance.

Product Drawing

Live Chat