8 channel video, power and data distribution unit. Systems operate with other Nitek UTP video equipment including video hubs, standard video balun transceivers, active transmitters or any twisted pair equipped camera.

This simple to install wall mounted locking cabinet contains a UTP video receiver and is integrated with a 28VAC eight channel power supply. The PV824 transmits video, power and data through the UTP cable. The cable terminates with a standard RJ45 networking connector. Video, camera power and data will be separated from the cable through a VB43ATF or VB31AT video balun.

(more info)

4 port passive video, power and data distribution unit. The PVX44 utilizes standard 4-pair Category UTP cabling as a means of distributing video, power and data up to 4 cameras. Any third party Class 2 power supplies can be used with the PVX44. VB43ATF video, power and data transceievers are required at the camera end. The PVX44 transmits 4 video signals from the cameras into one 4-pair Category cable. Nitek ‘M’ series hubs can be used for quick and secure installations.

(more info)

The VB31AT is a unique transmission device which provides an economical means of sending video and camera power over a standard Category cables. Video is sent over one pair and camera power is sent over the two of the remaining pairs. A mini-coax pigtail with male BNC is used on the VB31AT. A pair of wires are provided for power power connection. Connections to the Category cable are made via an RJ45 connector.

(more info)

4 port passive video, power and data distribution unit. The PVX44 utilizes standard 4-pair Category UTP cabling as a means of distributing video, power and data up to 4 cameras. Any third party Class 2 power supplies can be used with the PVX44. VB43ATF video, power and data transceievers are required at the camera end. The PVX44 transmits 4 video signals from the cameras into one 4-pair Category cable. Nitek ‘M’ series hubs can be used for quick and secure installations.

(more info)

The POE48 card can provide power for up to four Power over Ethernet cameras. The POE48 also provides the means to connect the four IP cameras to a network device; i.e. hub, switch, etc. Up to four POE48 cards may be plugged into a CX452 chassis to power a total of 16 POE devices. In this way the UTPLinks system may be used to power and crossover both IP and standard analog cameras in the same structured cabling network.

(more info)

Video balun transceiver with pigtail coax and male BNC for twisted pair operation with other balun transceiver or active receivers. Transmits up to 750 feet (229 meters) with passive transceivers or up to 3,000 feet (914 meters) with active receivers. The newly redesigned product offers screwless push terminals instead of screw terminals.

(more info)