Q: What is UTP wire?
Q: Can shielded twisted pair be used?
Q: What type of UTP wire works best for twisted pair video transmission?
Q: Is solid wire or stranded wire better for twisted pair transmission?
Q: Does the cable Category designation matter?
Q: What is Loop Resistance? How is it measured?
Q: Why do the wires have to be twisted?
Q: Can the wires be spliced or connected through punch-down blocks?
Q: What are MOV lightning protectors and why are they a problem?
Q: Is there any type of surge protection that can be used with the NITEK systems?
Q: What are T-Taps or Bridge Taps and why are they a problem?
Q: Can twisted pair video signals share a common cable with other signals?
Q: How many video signals can be run in a common cable?
Q: Can video signals be run in opposing directions in a common cable?
Q: Can twisted pair video signals be run near primary power lines?
Q: Can video signals be multiplexed over a single twisted pair?
Q: Can transmission distance be increased if two cable pairs are paralleled?
Q: Can the video signal be repeated to extend operating range?
Q: What are the DIP switches on the NITEK active transmitters and receivers used for?
Q: How can pan/tilt/zoom control be done with a NITEK UTP video system?
